Tempering Temperature and Wear Resistance of Hardfaced Die Surfaces
Overview of the Study
This paper by Xu Wujiao and colleagues from Chongqing University addresses a question that has cost me more than one sleepless night on the shop floor: what tempering temperature gives you the best wear life out of a hardfaced die. The authors used a universal testing machine, optical microscopy, hardness testing, and a friction-wear tester to evaluate the performance of hardfacing material on a microcar intermediate shaft die at different tempering temperatures. The work is straightforward in method but the conclusion is the kind of thing you want pinned to the wall of every tool room: at 500°C tempering, the hardfacing layer achieves maximum tensile strength, high hardness, and a microstructure where carbide particles are uniformly and finely dispersed in the matrix, forming a particle-reinforced composite layer with the best wear resistance.
Microstructural Evolution and Mechanical Properties
The key insight here is that tempering is not just about relieving residual stress—it is about engineering the carbide distribution. At 500°C, the carbides precipitate as small, rounded particles rather than as coarse grain-boundary films. This is the classic difference between a wear-resistant microstructure and a brittle one. The authors report that the tensile strength peaks at this temperature, which tells me that the matrix is still sufficiently strong to hold the carbides in place under abrasive and adhesive wear conditions. If you temper too low, you keep the as-welded hardness but you also keep the as-welded brittleness, and the die will crack in service. If you temper too high, you soften the matrix and the carbides begin to coarsen and lose their anchoring effect, and then the die wears out quickly. The 500°C window is the sweet spot.
Practical Implications for Die and Tooling Life
In my thirty years of running pipe mills and fitting shops, I have seen hardfaced rolls, mandrels, and forming dies fail in every conceivable way. The most common failure mode is not gross fracture but progressive surface degradation: galling, spalling, and abrasive wear that changes the die geometry and pushes the product out of tolerance. This paper confirms what I have learned the hard way: if you do not control the tempering cycle, you are throwing away the performance of the hardfacing alloy. For a pipe forming roll, a die that lasts 10,000 pieces instead of 2,000 pieces is a direct saving in downtime, regrinding, and replacement cost. The 500°C recommendation is directly transferable to our industry, provided the hardfacing alloy is similar in composition.
Lessons from the Shop Floor
I recall a job where we hardfaced a set of mandrel plugs for a seamless tube mill and then tempered them at 650°C because the heat treatment shop thought "higher is better" for stress relief. The plugs lasted less than half their expected life. The carbides had coarsened, the matrix had softened, and the surface literally smeared under the hot working loads. We re-tempered a new set at 500°C and the life more than doubled. That is the practical difference this paper is talking about. Another lesson: tempering temperature must be measured on the part, not just set on the furnace controller. In a large die, the core temperature lags the surface, and if you soak for too short a time, you get a gradient that causes differential transformation and residual stress.
Conclusion
This study gives the hardfacing community a clear, defensible process window: temper at 500°C to get a fine, uniformly dispersed carbide structure that maximizes both strength and wear resistance. The practical takeaway for pipe and fitting manufacturers is that die life is not just a function of the hardfacing alloy—it is a function of the complete thermal cycle. I have signed off on thousands of tonnes of product made with hardfaced tooling, and I can tell you that the difference between a good die and a bad one is often just 50°C of tempering temperature. Follow the data, measure the part temperature, and your tooling will reward you with consistent quality and lower cost.
Zhuojin Pipe Fitting Co., Ltd