Plasma Surfacing of Mining Picks: A Practical Review
Background and Context
Mining picks are subjected to severe abrasive wear in coal seams, often leading to premature failure and high replacement costs. The paper by Cheng et al. addresses this by applying plasma surfacing with TiC-containing alloy powders. This is a classic example of surface engineering to extend component life. From my experience, the key is not just the coating hardness but the metallurgical bond and the distribution of hard phases. The paper uses a transferred plasma arc to melt the powder and form a metallurgical bond with the substrate, which is critical for avoiding spalling under impact loads.
Process and Coating Design
The process parameters and powder composition are critical. The paper investigates four different powder blends with varying TiC content. The transferred plasma arc provides high energy density, allowing for a relatively thin but well-bonded coating. The table below summarizes the typical parameters and compositions.
| Powder Blend | TiC Content (wt.%) | Hardness (HRC) | Wear Resistance (Relative) |
|---|---|---|---|
| 1 | 10 | 52 | 1.0 |
| 2 | 20 | 55 | 1.3 |
| 3 | 30 | 58 | 1.6 |
| 4 | 40 | 60 | 2.1 |
As the TiC content increases, the hardness and wear resistance improve, but the toughness decreases. In practice, there is a trade-off. For picks that experience impact, a high TiC content may lead to chipping. I have seen components fail prematurely due to excessive hardness with insufficient toughness.
Wear Performance and Metallurgical Analysis
The wear tests show that increasing TiC content significantly improves wear resistance. The mechanism is that TiC particles act as hard reinforcements, resisting abrasive cutting. The metallurgical bond ensures that the coating does not delaminate. However, the paper does not discuss the effect of TiC particle size or distribution, which is equally important. In my experience, a uniform distribution of fine TiC particles provides better wear resistance than coarse agglomerates.
Shop Floor Implications
For practical application, the process must be reproducible. Plasma surfacing requires precise control of arc current, powder feed rate, and travel speed. In a production setting, I would insist on a pre-qualification procedure for each batch of powder. The coating thickness should be monitored to avoid excessive dilution from the substrate, which can reduce hardness. Also, the substrate must be clean and preheated if necessary to avoid cracking. I have seen failures where insufficient preheat led to solidification cracking in the coating.
Conclusion
The study demonstrates that plasma surfacing with TiC-containing powders is a viable method to improve the wear resistance of mining picks. The key is to balance TiC content with toughness. For field applications, I would recommend a TiC content of 20-30% for picks subject to moderate impact, and 30-40% for purely abrasive conditions. The process requires careful quality control to ensure consistent coating properties. Ultimately, the economic benefit depends on the extended service life versus the cost of the process. In my experience, a 50% increase in service life justifies the additional cost of surfacing.
Zhuojin Pipe Fitting Co., Ltd