ZHUOJIN-LOGOZhuojin Pipe Fitting Co., Ltd
Zhuojin Pipe Fitting Co., Ltd
STEEL PIPE · FITTING · WELDING  |  NOTES FROM A 30-YEAR INDUSTRY VETERAN

Microstructural Features of NiCrBSi Alloy Focused Beam Cladding

Introduction to the Process

The paper by Shan et al. investigates the use of a focused beam heat source to clad NiCrBSi self-fluxing alloy powder on 45 steel. This is a rapid solidification process that produces a fine microstructure. The focused beam provides a high energy density, resulting in a small heat-affected zone (HAZ) and minimal distortion.

Microstructure of the Cladding Layer

The cladding layer consists of primary γ-Ni dendrites in a eutectic matrix. The eutectic is mostly M23(C,B)6 + γ-Ni, with some γ-Ni + Ni3Si lamellar eutectic. The hardness of the cladding is significantly higher than the substrate due to the presence of hard phases. The table below shows the typical phases and hardness.

Phase Hardness (HV)
γ-Ni dendrite 300-350
M23(C,B)6 + γ-Ni eutectic 500-600
Ni3Si lamellar 450-500
Substrate (45 steel) 180-220

Heat Affected Zone and Interface

The interface shows a semi-melted zone where the substrate partially melts, ensuring a metallurgical bond. The HAZ transforms from austenite to a pearlite-like structure. The depth of the HAZ is small due to the rapid cooling. This is beneficial for maintaining the substrate properties.

Practical Implications for Hardfacing

The focused beam process offers advantages such as low dilution and minimal distortion. However, it requires precise control of the beam parameters. In practice, this process is suitable for small components or areas requiring precise cladding. For large components, other processes like laser cladding or plasma transfer arc may be more efficient. The key is to match the process to the component geometry.

Conclusion

The study provides a detailed microstructural analysis of NiCrBSi cladding produced by focused beam. The fine microstructure and strong bond are beneficial for wear resistance. For practical applications, I would consider this process for components like valve seats or small shafts. The process must be qualified with proper parameter control and inspection. The economic benefit depends on the component value and the required service life.