Ultrasonic-Assisted Plasma Arc Surfacing of Ni60AA: NDT and Performance Insights
Introduction
The paper by Zhang Ning and colleagues investigates the use of ultrasonic vibration during plasma arc surfacing of Ni60AA alloy and the application of phased array ultrasonic testing (PAUT) for defect detection. This is a practical topic for anyone involved in hardfacing of components that must withstand wear and corrosion. In my years on the shop floor, I have seen many hardfacing jobs fail because of lack of fusion or porosity that was not detected until the part was in service. The combination of ultrasonic assistance to reduce defects and PAUT to detect them reliably is a significant step forward.
Key Technical Points
The study compares three NDT methods: TOFD, PA sector scan, and PA linear electronic scan. The results show that PA sector scan and linear electronic scan are more suitable for single-pass weld detection than TOFD. This is not surprising: TOFD is excellent for planar defects in thick sections, but for thin hardfacing layers, the beam geometry and near-surface resolution are limited. PAUT offers better control of the beam angle and focal depth, making it more sensitive to small volumetric defects.
The effect of ultrasonic power on defect formation is summarized in the table below.
| Ultrasonic Power (W) | Defect Type Observed | Defect Severity |
|---|---|---|
| 0 | Lack of fusion, large porosity | High |
| 400 | Small porosity and inclusions | Moderate |
| 800 | No obvious defects | None |
The mechanism is that ultrasonic vibration promotes the escape of gas bubbles and improves the wetting between the molten pool and the substrate, reducing lack of fusion. The microstructure becomes finer and more uniform, which directly improves hardness and wear resistance. The study reports that at 800 W, the coating quality is best.
Practical Implications
In real production, hardfacing is used on valve seats, pump components, and pipe fittings that are subject to abrasive and erosive wear. The ability to produce a defect-free layer is critical. However, ultrasonic assistance requires additional equipment and careful control of the transducer position and power. It is not a simple add-on; the ultrasonic horn must be properly coupled to the workpiece, and the vibration frequency and amplitude must be matched to the solidification rate.
From an NDT standpoint, PAUT is more intuitive and has a higher detection rate than conventional UT. But it requires skilled operators and appropriate calibration blocks. In my experience, many shops still rely on magnetic particle or dye penetrant for surface defects and conventional UT for volumetric defects. PAUT, with its ability to produce sector scans and C-scan images, is a game-changer for hardfacing quality control, especially for complex geometries.
Conclusion
The paper demonstrates that ultrasonic-assisted plasma arc surfacing can significantly reduce welding defects and improve the mechanical properties of Ni60AA coatings. PAUT is a reliable and visual method for detecting defects in such layers. For the industry, this means that we can now produce high-quality hardfacing with confidence, provided we invest in the right equipment and training. The 800 W optimum is a useful starting point, but each application may require its own tuning. I would recommend that any shop considering this process first conduct a feasibility study on representative components, with PAUT verification of every layer.
Zhuojin Pipe Fitting Co., Ltd