Rare Earth Oxide Effects on High Hardness Hardfacing Metal: Toughness vs Hardness
Introduction
The paper by Cheng Zhonggeng and colleagues investigates the effect of yttrium oxide (Y2O3) on the microstructure and properties of a high hardness alloy steel hardfacing metal. The motivation is clear: high hardness hardfacing alloys often suffer from poor toughness, leading to spalling and cracking in service. Rare earth oxides are known to refine grains and modify inclusions, but their effect on the hardness-toughness balance is not well documented.
Technical Analysis
The study added Y2O3 in varying amounts to the flux or electrode coating. The results show that with 3% Y2O3, impact toughness increases by 39%, while hardness decreases by only about 0.5 HRC. This is a very favorable trade-off. The microstructure becomes a mixture of martensite, retained austenite, and dispersed carbide particles, which is described as ideal for high hardness applications.
The mechanism is that rare earth oxides act as deoxidizers and desulfurizers, purifying the weld metal and reducing the size and number of inclusions. The SEM and EDS analysis confirms that inclusions are refined and their morphology is more spherical. This reduces stress concentration and improves toughness. The slight hardness decrease is likely due to the refinement of the martensite and a small reduction in carbon equivalent.
The table below summarizes the effect of Y2O3 content.
| Y2O3 Content (%) | Impact Toughness (J) | Hardness (HRC) | Inclusion Size (μm) |
|---|---|---|---|
| 0 | 20 | 60 | 5-10 |
| 3 | 28 | 59.5 | 2-5 |
Practical Implications
In real applications, hardfacing is often used on components that experience both abrasive wear and impact, such as rock crusher hammers, excavator teeth, and pipe fittings in slurry service. A small loss of hardness is acceptable if the toughness improves significantly, because spalling and chipping are more common failure modes than simple abrasion.
The use of rare earth oxides in welding consumables is not new, but the specific effect on high hardness alloys is valuable. In practice, we must ensure that the rare earth oxide is uniformly distributed in the flux or electrode coating. Poor mixing can lead to inconsistent results. Also, the addition of Y2O3 may affect the arc stability and slag characteristics, so welding parameters may need adjustment.
Conclusion
The paper demonstrates that Y2O3 can improve the toughness of high hardness hardfacing metal with minimal hardness penalty. The ideal microstructure is a mixed martensite plus retained austenite with dispersed carbides. For the industry, this is a practical way to extend the service life of hardfaced components that are subject to impact and abrasion. However, the results are from laboratory coupons; we need to verify the performance on actual parts with complex geometries and under real service conditions. I would recommend that any shop using rare earth oxide additions start with a small percentage and carefully monitor the hardness and toughness of the deposited metal.
Zhuojin Pipe Fitting Co., Ltd