ZHUOJIN-LOGOZhuojin Pipe Fitting Co., Ltd
Zhuojin Pipe Fitting Co., Ltd
STEEL PIPE · FITTING · WELDING  |  NOTES FROM A 30-YEAR INDUSTRY VETERAN

Interface Quality and Workpiece Temperature in No-Penetration Hardfacing

Context and Objective

This study by Cheng Zhifu and Xu Yuelan from Nanjing University of Science and Technology tackles a problem that is often overlooked in hardfacing: what happens at the interface when you intentionally avoid penetrating the base metal? This is a common requirement when rebuilding worn shafts, rolls, or bearing journals, where you cannot afford to melt into the substrate because it would alter the metallurgy or cause distortion. The authors used thermocouple measurements and metallographic observation to analyze the temperature distribution during copper-steel hardfacing and its effect on the bond quality.

Experimental Approach and Findings

The study monitored temperatures at various positions during the hardfacing process and correlated them with the quality of the bond interface. The key finding is that the bond quality is directly related to the temperature reached at the interface. A good bond requires sufficient heat to create a metallurgical bond without excessive penetration. The authors identified a temperature window that produces a sound interface, and they propose using this relationship for real-time process control.

Temperature Zone Interface Condition Practical Consequence
Too low Lack of fusion, cold lap Deposit will spall off under load
Optimal range Sound metallurgical bond Deposit performs as intended
Too high Excessive dilution, base metal melting Distortion, cracking, loss of substrate properties

The practical significance here is enormous. When we rebuild a large mill roll or a ship shaft, we cannot afford to have the deposit peel off after a few weeks of service. The study provides a quantitative basis for controlling the process, which is far better than the old "look at the weld and hope" approach.

Field Application and Lessons Learned

I have personally seen the consequences of poor interface quality in hardfacing. On one occasion, we rebuilt a large hydraulic press ram with a stainless steel hardfacing, and the deposit spalled off after only two months of service. The cause was insufficient preheat and too low a welding current, which resulted in a cold lap at the interface. The cost of the rework, including grinding, re-hardfacing, and re-machining, was nearly three times the original job. This study would have prevented that failure.

The authors suggest using thermocouples for real-time temperature monitoring, which is a sound approach. In my experience, however, thermocouples are not always practical on large, rotating components. A more robust approach is to use infrared pyrometry or thermal imaging, which can monitor the temperature without contact. The key is to establish the relationship between the measured temperature and the interface quality, as this study has done, and then use that relationship as a control parameter.

Summary

This study provides valuable insight into the relationship between workpiece temperature and interface quality in no-penetration hardfacing. The finding that there is an optimal temperature window for achieving a sound bond is directly applicable to shop floor practice. For anyone involved in rebuilding worn components, this is essential reading. I would recommend that every hardfacing shop develop its own temperature-interface relationship for the specific materials and processes they use, because the optimal window will vary with the substrate, the deposit material, and the welding process. The investment in temperature monitoring equipment will pay for itself many times over by preventing premature failures and costly rework.