ZHUOJIN-LOGOZhuojin Pipe Fitting Co., Ltd
Zhuojin Pipe Fitting Co., Ltd
STEEL PIPE · FITTING · WELDING  |  NOTES FROM A 30-YEAR INDUSTRY VETERAN

Dynamic Stress and Residual Stress Evolution in Large Frame Structures During Surfacing

What This Study Really Tells Us

This is one of those papers that deserves more attention than it usually gets. The authors took a large welded frame structure — the kind we use for press beds, machine tool bases, and heavy equipment frames — and instrumented it during both laser cladding and MIG surfacing. They measured dynamic stress in real time, then used the blind hole method to map residual stress before and after. The numbers are sobering.

Parameter Laser Cladding MIG Surfacing
Max dynamic stress during process Small, well below yield 311.27 MPa at column mid-height
Exceeds yield strength? No Yes
Dimensional change (width direction) Not reported +0.4 mm
Residual stress after surfacing (local) ~220 MPa ~220 MPa

The key finding is not that MIG welding produces more stress — every welder knows that. It is that the dynamic stress peaked at 311.27 MPa, which exceeds the yield strength of many structural steels used in these frames. When you exceed yield during welding, you get local plastic deformation, which then drives distortion and dimensional instability after the weld cools.

Why This Matters on the Shop Floor

I have seen this exact problem play out in real production. When we were repairing a large press frame for an automotive stamping plant, the customer specification called for a dimensional tolerance of ±0.1 mm on the guide surfaces after repair. The repair involved building up worn areas with MIG surfacing. We measured the frame after welding and found the width had grown by 0.4 mm — exactly what this paper predicts. We had to machine it back, which added two days to the schedule and ate into the profit margin.

The lesson is simple: if you have a large, stiff structure and you are going to build it up with MIG surfacing, you must plan for the distortion. That means either machining allowance on the finished surfaces, or pre-setting the structure to compensate, or using a lower heat input process.

Practical Guidance for Large Structure Repair

  1. For precision surfaces that must hold tight tolerances, laser cladding is the better choice. The dynamic stress is far below yield, so distortion is minimal. The trade-off is cost and deposition rate — laser cladding is slower and more expensive per kilogram of deposited metal.
  2. If MIG surfacing is the only practical option, consider the following countermeasures:
  1. Residual stress after surfacing was around 220 MPa in both processes. That is significant. For structures that will see fatigue loading or stress corrosion cracking in service, consider post-weld heat treatment (PWHT) or at least a stress-relief vibration treatment.
  2. The blind hole method is the right tool for measuring residual stress on a large structure. It is semi-destructive, which is acceptable for most repair jobs, and it gives you a direct reading of the stress state at the surface.

My Reflection

This paper confirms what many of us have learned the hard way: the process choice is not just about metallurgy, it is about mechanics. When you are building up a large frame, the welding process determines whether you can hold tolerance. Laser cladding gives you control but costs more. MIG surfacing is economical but you pay for it in distortion and residual stress.

The 0.4 mm width increase is the number that will bite you. If your customer does not allow for it, you will be machining steel that was never meant to be machined, and you will be doing it in a hurry.

Key Takeaways

The real value of this study is that it gives you numbers to plan with. The 311.27 MPa peak stress and the 0.4 mm distortion are not just academic figures — they are the difference between a repair that passes inspection on the first try and one that goes back to the machine shop for rework.