ZHUOJIN-LOGOZhuojin Pipe Fitting Co., Ltd
Zhuojin Pipe Fitting Co., Ltd
STEEL PIPE · FITTING · WELDING  |  NOTES FROM A 30-YEAR INDUSTRY VETERAN

Robot-Based Hardfacing Additive Manufacturing

Literature Overview

This paper by Zhang Yu et al. from Nanjing University of Aeronautics and Astronautics, Capital Aerospace Machinery Company, and Tianjin University was published in Manufacturing Automation, Vol. 35, No. 11, 2013. It investigates robot-based hardfacing additive manufacturing (also known as wire arc additive manufacturing, WAAM) for producing dense metal parts.

The paper addresses two critical problems: crater collapse and surface roughness. These are the two issues that have historically limited the adoption of hardfacing-based additive manufacturing for producing functional components rather than just repair deposits.

The Crater Collapse Problem

Crater collapse occurs at the end of each weld pass when the arc is extinguished. The molten pool solidifies rapidly, leaving a depression or crater at the end of the deposit. In multi-layer deposition, these craters become stress concentrators and cause poor surface quality, requiring extensive machining.

The paper proposes three solutions:

  1. Reduce heat input - lower current and voltage reduce the molten pool size and minimize crater formation.
  2. Add crater filling action in the robot program - the robot performs a deliberate crater-filling motion (typically a circular or spiral movement) before extinguishing the arc to gradually reduce the molten pool and fill the crater.
  3. Overlap the welding paths - adjacent passes overlap slightly to compensate for the crater depression.

Surface Quality and Post-Processing

Even with optimal parameters, the as-deposited surface has a characteristic "weld bead" texture that is not suitable for functional surfaces. The paper demonstrates that electrolytic machining can be used as a post-processing method to achieve a smooth surface finish.

Process Step Purpose
Hardfacing deposition Build near-net shape
Electrolytic machining Remove weld bead texture, achieve final dimensions
Final inspection Verify dimensional accuracy and surface quality

Process Control Considerations

From my experience with automated welding systems, the key to successful hardfacing additive manufacturing is:

  1. Consistent wire feed - variations in wire feed speed cause bead width and height variations.
  2. Stable arc length - arc voltage control is critical for consistent deposition.
  3. Proper shielding gas flow - turbulence causes porosity.
  4. Interpass temperature control - excessive heat buildup causes distortion and grain growth.
  5. Robot path programming - the path must account for bead geometry to achieve uniform layer thickness.

Materials Demonstrated

The paper demonstrates the process on low-carbon steel and aluminum alloy. Both materials respond differently:

Summary

Robot-based hardfacing additive manufacturing has come a long way since this 2013 paper, but the fundamental challenges remain the same. Crater collapse is still the primary defect that must be managed, and the solutions proposed here - reduced heat input, crater filling, and path overlap - are still the standard approaches. The combination with electrolytic machining for post-processing is elegant because it avoids the thermal distortion that would occur with conventional machining. For anyone setting up a hardfacing additive manufacturing cell, I would emphasize that the robot program is only as good as the process parameters behind it. You need to characterize the bead geometry as a function of current, voltage, travel speed, and wire feed rate before you can write a meaningful path program. And always remember: the substrate condition matters as much as the deposition process. Clean, defect-free substrate surfaces are non-negotiable.