Laser Hardfacing of Ni-Based WC Gradient Coating and Wear Mechanism Analysis
Literature Overview
This paper by Qi Wenjun et al. from Guangzhou Research Institute of Non-ferrous Metals was published in Transactions of the Welding Institution, Vol. 23, No. 1, 2002. It presents a novel approach to producing WC gradient hardfacing layers on Q235 steel using laser hardfacing with coaxial synchronous powder feeding.
The significance of this work lies in the gradient design concept. Instead of a single uniform hardfacing layer, the composition is varied continuously from the substrate to the top surface, creating a smooth transition in hardness, wear resistance, and WC particle distribution.
Gradient Coating Design
The gradient design serves several purposes:
- Reduces thermal stress - the gradual change in thermal expansion coefficient between the steel substrate and WC-rich top layer minimizes residual stress.
- Improves bond strength - the interface is not a sharp boundary but a gradual transition, eliminating stress concentration.
- Optimizes wear resistance - the top layer has maximum WC content for wear resistance, while the intermediate layers provide toughness and support.
Process Control
The paper emphasizes that precise control of the powder feeding process is critical:
| Parameter | Effect |
|---|---|
| Powder feed rate | Controls deposition rate and composition gradient |
| Laser power | Controls melt depth and dilution |
| Travel speed | Controls layer thickness and heat input |
| Carrier gas flow | Affects powder delivery efficiency and deposition |
The development of a laser gun capable of continuous gradient deposition is a key achievement. By varying the powder feed rate of different powder streams (Ni-based alloy and WC), the composition can be changed continuously during deposition.
Microstructure and Hardness
The gradient structure shows:
- Near the substrate: predominantly Ni-based alloy with dispersed WC particles.
- Middle region: increasing WC content, fine dendrites.
- Top region: maximum WC content, high hardness.
The hardness varies gradually from the substrate to the top surface, with the top layer achieving the highest hardness. The WC particles are distributed in a gradient pattern, with higher concentration at the top and lower concentration near the substrate.
Wear Mechanism
The wear mechanism in the gradient coating is characterized by:
- Initial wear: WC particles provide hard points that resist abrasive wear.
- Steady state wear: the Ni-based matrix wears preferentially, exposing WC particles which then carry the load.
- Final stage: WC particles may be pulled out if the matrix is worn away excessively.
The gradient design ensures that the transition from substrate to coating is gradual, preventing catastrophic spalling that would occur with a sharp interface.
Practical Implications
For applications such as pump impellers, valve seats, and mining equipment components, laser hardfacing with gradient WC coatings offers significant advantages over conventional hardfacing:
- Lower dilution - laser hardfacing has much lower dilution than arc processes, preserving the coating composition.
- Precise control - the laser beam allows precise control of heat input and melt pool size.
- Gradient properties - the ability to tailor properties across the coating thickness is unique to this process.
However, the equipment cost is high, and the process is relatively slow compared to arc hardfacing. For high-volume production, the economics may not work. For critical components where performance justifies the cost, this is an excellent option.
Summary
This 2002 paper was ahead of its time. The concept of gradient hardfacing layers with controlled WC distribution is still relevant today, and the process control principles described here are still valid. The key insight is that you cannot simply deposit a thick WC-rich layer on steel and expect it to survive - the thermal expansion mismatch will cause cracking and spalling. The gradient approach solves this problem elegantly. For my own practice, I would apply this concept to components that experience severe abrasive wear combined with thermal cycling, where conventional hardfacing has a history of premature failure. The main limitation is the deposition rate - laser hardfacing is slow. But for the right application, the performance gain justifies the cost.
Zhuojin Pipe Fitting Co., Ltd