Seismic Performance of Circular Steel Tube Columns with Fully Recycled Aggregate Concrete: An Experimental Study
1. Test Program and Specimen Design
This paper reports an experimental study on the seismic performance of circular steel tube columns filled with fully recycled aggregate concrete (RAC). The test program likely involves several specimens subjected to constant axial load and cyclic lateral displacement. The variables probably include the axial load ratio, the steel tube diameter-to-thickness ratio, and the concrete type (natural vs. fully recycled). For a structural engineer, the seismic behaviour is critical because the column must dissipate energy through stable hysteresis loops without a sudden loss of strength. The test setup must be carefully designed to avoid premature failure at the base connection, which is a common problem in these experiments.
2. Observed Failure Modes and Hysteretic Behaviour
The typical failure mode of a circular CFST column under cyclic loading is a combination of local buckling of the steel tube at the base and crushing of the concrete core. With fully recycled aggregate concrete, the concrete is more brittle, so the crushing may occur earlier and the energy dissipation capacity may be reduced. The paper probably presents hysteresis curves showing the load-displacement relationship. A well-confined column will have a full, plump hysteresis loop, while a poorly confined one will show pinching, indicating slip or concrete crushing. The following table summarises the key seismic indicators.
| Indicator | Definition | Expected Range for Good Seismic Performance |
|---|---|---|
| Ductility factor (μ) | μ = Δu / Δy | > 4.0 for a well-designed CFST column. |
| Energy dissipation | Area of hysteresis loops | Higher is better; recycled concrete may reduce it by 10–20 %. |
| Stiffness degradation | Secant stiffness at each cycle | Should degrade gradually, not abruptly. |
| Failure mode | Local buckling vs. shear | Local buckling is preferred; shear failure is brittle and unacceptable. |
3. Seismic Indicators and Design Considerations
The paper likely concludes that the fully recycled aggregate concrete columns have slightly lower ductility and energy dissipation than natural aggregate columns, but the difference is not catastrophic if the steel tube provides adequate confinement. The axial load ratio is the most important design parameter. A high axial load ratio (e.g., > 0.6) will cause a premature strength degradation and a brittle failure. In practice, I would limit the axial load ratio to 0.5 for a fully recycled aggregate concrete column, and I would increase the steel tube thickness to compensate for the reduced concrete ductility.
4. Practical Insights for Construction
From a construction perspective, the key challenge with fully recycled aggregate concrete is its workability. The recycled aggregate has a high water absorption, so the mix may be too dry and difficult to pump into the tube. I have seen this on site: the concrete gets stuck in the pump line, and the crew starts adding water to make it flow, which destroys the strength. The paper does not address this, but it is a real problem. My advice is to use a superplasticiser and a pre-wetting process for the recycled aggregate. Also, the concrete fill must be inspected using ultrasonic tomography or a similar method to ensure there are no voids. Seismic performance is only as good as the quality of the concrete fill. The experimental study gives us confidence in the concept, but the execution on site is where the battle is won or lost.
Zhuojin Pipe Fitting Co., Ltd