ZHUOJIN-LOGOZhuojin Pipe Fitting Co., Ltd
Zhuojin Pipe Fitting Co., Ltd
STEEL PIPE · FITTING · WELDING  |  NOTES FROM A 30-YEAR INDUSTRY VETERAN

Flexural Bearing Capacity of Multi-Cavity Round-Ended Steel Tube Concrete Members

1. Member Configuration and Test Approach

This paper deals with a specific type of composite member: a multi-cavity round-ended steel tube concrete member. The cross-section is a rectangle with semicircular ends, and it contains multiple internal steel plates that divide the section into several cavities, each filled with concrete. This configuration is often used in bridge piers and building columns where a high flexural capacity is required in one direction and a high axial capacity in another. The test approach likely involves a four-point bending test on a simply supported member, with the load applied to induce a pure bending moment in the central region. The variables probably include the number of cavities, the thickness of the internal plates, and the concrete strength.

2. Flexural Behaviour and Bearing Capacity Analysis

The flexural behaviour of a multi-cavity section is more complex than a simple CFST because the internal plates act as webs, providing additional shear resistance and improving the composite action. The failure mode is typically a combination of local buckling of the steel tube in the compression zone and crushing of the concrete in the compression flange. The paper likely presents a strain distribution across the section, showing that the plane-section assumption holds reasonably well. The ultimate flexural capacity is usually calculated using a plastic stress distribution, where the steel is fully yielded and the concrete is at its compressive strength. The following table summarises the typical contributions.

Component Contribution to Flexural Capacity
Steel tube in tension Provides the main tensile force.
Steel tube in compression Contributes to the compression force, but may buckle locally.
Concrete in compression Provides a significant compression force, especially in the flanges.
Internal plates Act as webs, increasing the section modulus and preventing local buckling.

3. Design Method and Code Comparison

The paper probably proposes a simplified design formula based on the plastic section modulus and compares it with existing code provisions, such as EC4 or GB 50936. The comparison may show that the existing codes underestimate the capacity of multi-cavity sections because they do not account for the beneficial effect of the internal plates. In engineering practice, this is a common issue: codes are developed for standard sections, and new configurations require a specific design method. My advice is to use the proposed formula only after validating it with a full-scale test. I have seen a bridge pier designed with a similar multi-cavity section, and the contractor had to perform a mock-up test to verify the concrete filling process. The internal plates create narrow cavities that are difficult to fill, and voids can form if the concrete is not properly vibrated.

4. Concluding Remarks and Field Application

The study is a valuable contribution to the design of composite members. The multi-cavity round-ended section offers a high flexural capacity with a relatively small footprint, which is ideal for urban construction where space is limited. However, the construction challenges are significant. The internal plates must be welded with full penetration to avoid stress concentration, and the concrete fill must be carefully controlled. In a real project, I would require a detailed construction procedure, including the sequence of concrete pouring and the use of a high-flow, self-compacting concrete. The flexural capacity is only one aspect; the connection details at the member ends are equally important. A poorly designed connection can cause a premature failure that negates all the benefits of the multi-cavity section. The paper provides a solid foundation, but the engineer must think beyond the cross-section and consider the whole structural system.