ZHUOJIN-LOGOZhuojin Pipe Fitting Co., Ltd
Zhuojin Pipe Fitting Co., Ltd
STEEL PIPE · FITTING · WELDING  |  NOTES FROM A 30-YEAR INDUSTRY VETERAN

Light Square Steel Tube Recycled Concrete Columns: Axial Compression Test Insights

Overview

The paper by Liu Wenchao et al. on the axial compression behavior of light square steel tube recycled concrete columns addresses a real issue we face on site: how to use recycled concrete in structural members without compromising performance. The test program covered six specimens, varying concrete type, steel tube wall thickness, and recycled aggregate substitution. This is not just an academic exercise; it speaks directly to the growing demand for sustainable construction in light steel structures, where the tube wall is thin and the concrete core carries a significant share of the load.

Test Program and Parameters

The specimens were square tubes with a nominal cross-section, and the key variables are summarized below.

Parameter Values / Description
Specimen type Light square steel tube, hollow and concrete-filled
Concrete types Normal concrete, recycled concrete with varying replacement ratios
Steel tube wall thickness Two levels (e.g., 2 mm and 3 mm, typical for light steel)
Loading Axial compression, monotonic, with load-displacement and strain measurement
Measured responses Load-deformation, load-strain, energy dissipation, failure mode

The test matrix allowed the team to isolate the effect of concrete filling, recycled aggregate substitution, and tube wall thickness. From a production perspective, the wall thickness is critical because it controls local buckling and the composite action between the steel and concrete.

Key Results and Analysis

The results showed that the failure mode was primarily crushing of the concrete core with outward bulging of the steel tube at the ends, but no global bending was observed. This is typical for short columns where the steel tube provides confinement. The most important finding is that filling the hollow tube with recycled concrete significantly increased both the load-carrying capacity and the ductility. However, as the recycled aggregate substitution ratio increased, the enhancement effect diminished. This is a practical warning: recycled concrete is not a free lunch; the quality of the recycled aggregate, especially its water absorption and residual mortar content, directly affects the bond and the stiffness of the core.

Parameter Effect on Capacity Effect on Ductility
Concrete filling Large increase vs. hollow tube Significant improvement
Recycled aggregate substitution Decrease with increasing ratio Slight decrease
Tube wall thickness Increase with thickness Increase with thickness

The load-deformation curves showed that the recycled concrete columns had a steeper initial stiffness but reached a lower peak load compared to normal concrete columns. The ductility, defined as the ratio of ultimate deformation to yield deformation, was still acceptable for practical use.

Engineering Practice Implications

This work has direct relevance to the design and construction of light steel frame buildings, particularly where recycled concrete is available from demolition waste. In my experience, the key practical points are:

  1. The steel tube must be properly filled and compacted; voids in the concrete core will cause premature local buckling and reduce the composite action.
  2. The recycled aggregate should be pre-wetted and the mix design adjusted for its higher water absorption; otherwise the workability and strength will be inconsistent.
  3. The tube wall thickness should not be reduced below the minimum required to avoid local buckling, especially when the concrete strength is high.
  4. The connection details at the column ends must be designed to transfer the load into the concrete core, not just the steel wall.

These columns have been used in low-rise residential and industrial buildings, and the test data support their use with a reasonable safety factor. The reduction in capacity due to recycled aggregate should be accounted for in the design, perhaps by applying a reduction factor to the concrete contribution.

Conclusions

The study confirms that light square steel tube recycled concrete columns are a viable structural solution, provided the recycled aggregate quality is controlled and the design accounts for the reduced performance. The practical takeaway is that we can use recycled concrete in light steel structures without sacrificing safety, but we must be diligent in material selection and construction quality. This is a step forward for sustainable construction, and I would encourage further testing on long-term behavior and fire resistance, as those are the areas where the industry still lacks confidence.