ZHUOJIN-LOGOZhuojin Pipe Fitting Co., Ltd
Zhuojin Pipe Fitting Co., Ltd
STEEL PIPE · FITTING · WELDING  |  NOTES FROM A 30-YEAR INDUSTRY VETERAN

Temperature Field of Debonded Concrete-Filled Steel Tube Members: A Practical Review

Introduction

This study by Chen Baochun and Liu Zhenyu addresses a problem that has haunted bridge engineers for decades: the debonding of the concrete core from the steel tube in concrete-filled steel tube (CFST) arches. The paper investigates how this debonding affects the temperature field under solar radiation, which is critical because temperature gradients drive internal stresses and can accelerate the debonding itself. As someone who has supplied thousands of tonnes of steel pipe for CFST bridges, I can tell you that debonding is not just a theoretical concern—it is a real risk that we must design against and inspect for.

Key Findings and Technical Parameters

The researchers tested two full-scale debonded CFST members: one vertical and one horizontal. They measured the temperature field under natural sunlight and compared it with finite element results. The key innovation was treating the debonded interface as a fourth-type boundary condition—air in contact with both steel and concrete—rather than assuming perfect bond. The results are summarised in the table below.

Parameter Effect of Debonding Magnitude Trend
Steel tube surface maximum temperature Increases Increases with gap size
Steel tube surface minimum temperature Decreases Decreases with gap size
Concrete core maximum temperature Decreases Decreases with gap size
Concrete core minimum temperature Increases Increases with gap size
Gap size variation with temperature Changes, but small Increases with tube diameter and initial gap

The practical implication is clear: debonding makes the steel tube hotter at the top and colder at the bottom, increasing the temperature differential across the section. This amplifies the thermal stresses that the tube must carry, potentially leading to local buckling or fatigue issues. The study also found that the gap size itself fluctuates with temperature, but the variation is generally small—except for small gaps and large diameters, where the gap can close completely. That closure is actually a positive effect, as it restores some composite action.

Practical Implications for CFST Bridges

In my experience, debonding in CFST arches typically arises from three sources: shrinkage of the concrete, insufficient interface treatment, and poor compaction during pumping. The temperature field results tell us that a debonded member behaves differently under solar loading, which means the design temperature gradient must be adjusted if debonding is suspected. For a 200 mm diameter tube, a 2 mm gap can raise the steel surface temperature by several degrees Celsius, which may seem small but is significant when combined with live load stresses. I have seen bridges where this led to cracking of the concrete core, and the repair costs were substantial.

Manufacturing and Delivery Considerations

From a steel pipe supplier's perspective, this study reinforces the importance of dimensional accuracy and surface quality. The gap size is directly influenced by the pipe's internal diameter tolerance and the concrete's shrinkage characteristics. We must ensure that the pipe's internal surface is clean and free of mill scale, oil, or rust before concrete placement, as any contamination reduces bond strength. The paper's finding that gap closure is more likely for small gaps and large diameters suggests that for large-diameter tubes, we should aim for a very tight fit—perhaps even a slight interference fit—to minimise initial debonding. In practice, we often specify a roughened internal surface or weld shear studs to improve bond, as discussed in Topic 4.

Conclusion

This study provides a solid experimental and numerical foundation for understanding the thermal behaviour of debonded CFST members. The key takeaway for engineers is that debonding is not a benign condition; it alters the temperature field and thus the structural response. For manufacturers, it underscores the need for precise pipe fabrication and rigorous quality control to prevent debonding at the source. I would recommend that any CFST bridge design include a sensitivity analysis for partial debonding, and that inspection procedures incorporate thermal imaging to detect gaps during service. The paper is a valuable contribution to the field, and its boundary condition approach is a practical tool for finite element modelling.