ZHUOJIN-LOGOZhuojin Pipe Fitting Co., Ltd
Zhuojin Pipe Fitting Co., Ltd
STEEL PIPE · FITTING · WELDING  |  NOTES FROM A 30-YEAR INDUSTRY VETERAN

Ambient Temperature Effects on Axial Compressive Capacity of Concrete-Filled Steel Tube Columns

Background and Motivation

The paper by Pan et al. addresses a critical issue for structures in cold regions: the effect of ambient temperature on the axial compressive capacity of concrete-filled steel tube (CFST) columns. The study is motivated by the need for design guidance in high-altitude and large-temperature-difference regions, such as the Qinghai-Tibet Plateau and northern China. The authors conducted tests on CFST short columns at temperatures ranging from 20°C down to -40°C.

Experimental Program and Results

The test results show a significant increase in capacity as temperature drops. At -40°C, the capacity increased by up to 34.3% compared to 20°C. This is due to two mechanisms: the concrete freezes and its strength increases, and the steel tube's yield strength also increases at low temperatures. However, the ductility decreases, and the risk of brittle failure increases. The confinement effect of the steel tube is enhanced, but the concrete becomes more brittle.

Theoretical Derivation and Validation

The authors derived a theoretical formula based on the limit equilibrium method, incorporating the temperature-dependent material properties. The calculated values agree with the test results within 10% relative error. This is a practical formula for design. The key is to use the correct temperature-dependent material properties for both the steel and the concrete.

Practical Implications for Cold-Region Structures

For structures in cold regions, the design must account for the increased capacity but also the reduced ductility. The steel tube must have sufficient low-temperature toughness to avoid brittle fracture. The concrete mix should be designed for low-temperature performance, with appropriate air entrainment and admixtures. In my experience, the construction of CFST columns in cold regions requires special attention to the concrete placement and curing. The concrete must be protected from freezing during placement, and the steel tube must be preheated if necessary.

Reflections and Lessons

The study provides valuable data, but it is based on short columns. The effect of temperature on long columns and on the bond-slip behavior should be investigated. For the shop, the lesson is in the material selection. For the site, the lesson is in the construction practices in cold weather. I would recommend that the design formula be used with caution for extreme temperatures below -40°C, and that the ductility be checked separately. The increase in capacity should not be used to reduce the section size without considering the ductility requirements.