ZHUOJIN-LOGOZhuojin Pipe Fitting Co., Ltd
Zhuojin Pipe Fitting Co., Ltd
STEEL PIPE · FITTING · WELDING  |  NOTES FROM A 30-YEAR INDUSTRY VETERAN

Gravity Separation SHS Alumina Lining for Steel Pipe

Core reaction and coating structure

The paper reports gravity separation self propagating high temperature synthesis to form an alumina based inner lining inside steel pipe. The main phases are alpha alumina plus iron aluminate spinel, and a metallic transition layer forms between the steel tube and ceramic layer. This is important because the lining is not just a coating sprayed on the surface; it is a reaction product that depends on heat flow, gravity, melt behavior, and tube bore size. The reported best additive combination is 2 percent silica plus 6 percent chromium oxide, giving minimum porosity, maximum hardness, and good thermal shock resistance. The test condition with 25 cm tube diameter and packing density 1.5 g per cubic centimeter produced hardness around 1917 HV and porosity around 9.0 percent.

Process windows and material judgement

Parameter Reported value or trend Shop floor meaning
Main phase alpha alumina plus iron aluminate Good ceramic continuity and bonding
Best additive 2 percent silica plus 6 percent chromium oxide Improves density and thermal shock response
Tube diameter 25 cm tested Heat transfer and gravity separation scale with bore
Packing density 1.5 g per cubic centimeter Controls reaction stability and coating uniformity
Hardness about 1917 HV Wear resistance is attractive for abrasive service

From a pipe maker’s perspective, the attraction is obvious: an internally hardened bore can extend life in abrasive or hot particulate service. The caution is equally obvious: ceramic linings are brittle, and the transition layer must be continuous enough to carry thermal cycling without cracking. I have seen lined pipe fail not because the ceramic was soft, but because the steel substrate moved, the bore was oval, or the lining was damaged during handling. The process must control charge mixing, packing density, ignition stability, and cooling rate. If the reaction runs too hot, the steel tube can overheat and distort; if it runs too cold, the ceramic layer becomes porous and weak. The paper gives a useful window, but plant scale requires repeatable thermal control and bore inspection.

Field service and delivery issues

For delivery, the critical issue is protection of the bore. A hard alumina lining can chip if the pipe is dropped, dragged, or stacked with hard spacers. It can also be damaged by welding near the lined end unless the lining is masked or cut back. QA should include bore visual inspection, thickness check, adhesion check by approved method, and, where required, thermal shock sampling. The 9.0 percent porosity figure is not a defect by itself, but it tells the buyer that the lining is not dense like sintered ceramic tile. In corrosive service, porosity can allow media to reach the transition layer and the steel substrate, so the lining must be matched to the actual service chemistry, not just to a laboratory wear test. This paper is valuable because it shows a route to a metallurgically bonded inner liner, but the pipe plant must treat the lining as a system, not as a simple internal coating.